ONGA LEISURETIME POOL PUMP LTP550 - 550w 0.75hp
The Onga LTP550 suits small and medium sized pools up to 30,000 litres.
Benefits:
The range of Leisure Time pool pumps have been purposefully designed to provide maximum performance and corrosion resistance at a realistic cost.
Features:
• Electrical approvals - Leisuretime pool pumps have passed all stringent Australian Standards for safety and is approved for installation within the wetted zone of the pool area.
• Elevated motor foot - Incorporating an elevated mount into the pump design keeps moisture well away from the motor.
• Double coated endshield - Unique double zinc plated cast iron endshield for better corrosion protection extending the life of the pump.
• Large hair & lint pot - Easy to clean large hair & lint pot with a clear lid so you can check at a glance whether it is full or not.
• Low friction lint pot O-ring - Having a low friction O-ring on the lint pot means you only need to tighten the lid by hand.
• Self-aligning barrel unions - Onga's unique 5 degree self-aligning barrel unions make pipework connection a breeze.
• 2 year limited warranty. Terms and conditions apply.
Leisuretime Pump Maintenance:
The only routine maintenance needed is inspection/cleaning of leaf basket. Debris or trash that collects in basket will choke off water flow through the pump. Follow instructions below to clean leaf basket:
1. Stop pump, disconnect from power, close gate valve in suction and discharge.
2. Unscrew lid (turn counter clockwise). If necessary, undo drain plug to reduce lid vacuum. Do not hit the lid with a hammer or similar tool. If the lid is still too tight use a lever such as a board or long screwdriver between lugs on lid.
3. Remove leaf basket and clean. Be sure all holes in basket are clear, flush basket with water and replace in bowl assembly with large opening at pipe connection port (between ribs provided). If basket is replaced backwards the lid will not fit into bowl assembly.
4. Inspect, check and lubricate lid ‘O’ring; reinstall onto bowl assembly.
5. Clean ‘O’ring groove on bowl assembly and replace lid. To help keep lid from sticking,( tighten hand tight only no wrenches!).
6. Prime Pump (see priming instructions)
Learn More